Service Manual
Table Of Contents
- Revision History
- Preface
- Chapter 1 : Safety
- Chapter 2 : Specifications and Maintenance
- Chapter 3 : Troubleshooting
- Chapter 4 : Engine
- Chapter 5 : Chassis
- General Information
- Service and Repairs
- Caster Fork and Bearing Replacement
- Caster Wheel Replacement
- Left Console Replacement
- Right Console Replacement
- Seat Replacement
- Fuel Tank Replacement
- ROPS (Roll Over Protection System) Replacement
- Throttle Cable Assembly Replacement
- Choke Control Assembly Replacement
- Park Brake Handle Assembly Replacement
- Adjusting the Park Brake
- Motion Control Damper
- Motion Control Assembly Replacement
- Adjusting the Motion Control Handle Position
- MYRIDE® Replacement
- Chapter 6 : Deck
- Chapter 7 : Drive System
- Chapter 8 : Electrical
- Appendix A: Foldout Drawings
- Electrical Schematic
- Kawasaki Engine Electrical Schematic
•1-PTOSwitch
•2-OperatorPresenceSwitch,SafetyInterlockSwitches
•3-StartingCircuit
•4-Regulator,ChargingCircuit
•5-BatteryVoltageIn
g336416
Figure83
Key/IgnitionSwitchTest
1.Removethecontrolpanelfromtherightconsole.
2.Disconnecttheignitionswitchfromthewireharness.
3.Usingadigitalmulti-metersettotheOHMorContinuitysetting,verifythat
continuityexistsbetweentheterminalslistedforeachswitchposition.
4.Usingadigitalmulti-metersettotheOHMorContinuitysetting,verifythat
NOcontinuityexistsbetweentheterminalsnotlistedforeachswitchposition.
Position
Circuit“Make”
OFF
None
RUNB+R+I+A
STARTB+R+I+S
Hourmeter
ThehourmeterrecordshoursofoperationwhentheignitionkeyisONandthe
PTOswitchisON.
HourmeterTest
WiththeignitionswitchintheRUNpositionandthePTOswitchclosed(ON),
verifybatteryvoltageandgroundtothehourmeter.
Electrical:ServiceandRepairs
Page8–6
2000SeriesZMASTER®ServiceManual
3438-778RevA