Service Manual

4-6
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
CONTROL PLATE (THROTTLE AND CHOKE)
Adjustments
Throttle Cable (Figure 5)
1. Move control lever to “fast speed” setting (full forward) and hold.
NOTE: There is a slight detent.
2. Loosen the clamp.
3. Pull the conduit to the right to remove slack in the cable.
4. Tighten the clamp on the control plate.
5. Verify all linkages are free to move.
6. Check top no-load RPM; see “Top No-Load RPM,” chapter 4, page 4-9.
Figure 5