Service Manual

9-34
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Carburetor
NOTE: Complete disassembly, inspection, and assembly, chapter 3, page 3-1.
1. Install the gasket, spacer, and gasket onto the intake manifold studs.
2. Slide the carburetor onto the intake manifold studs.
3. Route fuel solenoid wire up and under the intake manifold. Connect the fuel solenoid wire into the wire harness
(Figure 37).
4. Install the choke link to the choke pivot on the control plate, then insert onto the choke override lever on the
carburetor, lock by rotating the clip over the link (Figure 38).
Figure 37
Figure 38