Service Manual

30 ZT-2800
®
/ZT-3100™/ZT-3400™
Figure 24, Bypass Arm
RefertoFigure24
Disassembly
1. Requires removal of all items beginning on
page 14.
2. Remove the push-on retaining ring (35) and
discard. Remove the bypass arm (34).
3. Remove the retaining ring (33).
4. Remove the bypass rod (32) and the clip
retaining ring (31) as a single item.
NOTE: Itisnotnecessarytoremovetheclip
retainingring(31)fromthebypassrod
(32)unlessitisdamagedorworn.
5. Remove the lip seal (30) and discard.
Inspection
1. Inspect the bypass rod (32) for wear or dam-
age. Replace if necessary.
NOTE: Takecaretoinsurethatthebypassrod
isfreeofburrsthatmaycuttherubber
lipseal.
BYPASS ARM
Assembly
1. Install a new lip seal (30).
2. Install the clip retaining ring (31) and bypass
rod (32).
3. Install the retaining ring (33).
4. Install the bypass arm (34) and new push-on
retaining ring (35).
35
31
34
33
32
30