Service Manual

HYDRO-GEAR TRANSAXLE

TimeCutter



Z Service Manual 4 - 3

5. Remove the bolt, washer, and spacer retaining the

brake arm on both the right and left transaxles.

Make sure dirt and debris is cleaned off around

the vent hose connected to each transaxle, then

remove the vent hoses. Cover the open hole in

each transaxle with tape to prevent dirt entry

(Figure 31).

Figure 31

mvc-096

6. Loosen the four bolts and nuts holding the

transaxles to the hydro support brackets (Figure

32).

Figure 32

mvc-099

7. Remove the 4 bolts and washers on the left side

of the frame (Figure 33).

Figure 33

mvc-739

8. Remove the 4 bolts located on the right side of the

frame (Figure 34).

Figure 34

mvc-736