Service Manual

shaft or grease will push out that opening.
28. Install the blade and torque the blade bolt
to 85-110 ft/lbs.
29. Install the drive belts. Consult the machine
owner's manual for this procedure.
30. Replace the deck covers.
31. Remove the machine from the jack
stands.
8 Spindle Repair Module
Z Master 200 Series
Nut
Zerk
Hardened Washer
Pulley
Seal
Spindle
Housing
Bearing Cone
Large Spacer
Bearing Cup
Small Spacer
Machine “C” Spacer
Snap Ring
Bearing Cup
Bearing Cone
Seal
Bearing Spacer
Spindle Shaft
Blade Bolt
Spring Washer
Grease Axis Hole
Blade