Setup Instructions

Step

Installing the Rollover

Protection System (ROPS)

Parts Needed for This Step

Qty. Part

1 Roll bar, right section

1 Roll bar, left section

1 Roll bar, center section

8 Bolt, 3/8 x 1 inch

8 Curved washer

8 Flange nut, 3/8 inch

2 Bolt, 1/2 x 3-1/4 inches

2 Flange nut, 1/2 inch

2 Lanyard

Procedure

1. Loosely install the right and left roll bar sections

to the frame, using 8 bolts (3/8 x 1 inch), 8 curved

washers, and 8 flange nuts (3/8 inch).

m-6916

2. Install the lanyard

clips onto the 2 bolts

(1/2 x 3-1/4 inches).

Note: Make sure the

bent tab points toward

the head of the bolt.

m-7410

3. Lightly oil the ends

of the center roll bar

section.

4. Loosely install the

center roll bar section,

using 2 bolts

(1/2 x 3-1/4 inches) and

2 flange nuts (1/2 inch).

Note: Make sure the

bolts are installed on the

outside of the roll bar.

Note: Make sure the

lanyard tab is installed

as shown and points

forward.

m-7432