Service Manual

32. Install the pulley on the pulley hub and
torque the bolts to 27-33 ft.-lbs.
33. Install the blade and torque the blade bolt
to 85-110 ft.-lbs.
34. Install the drive belt. Consult the opera-
tor's manual for the proper procedure.
35. Replace the deck covers. Remove the
machine from the jack stands or Z Stand®.
14 Spindle Repair Module
Z Master 500 Series
Nut
Square Key
Bearing
Shield
Seal
Bearing
Shield
Spindle
Shaft
Seal
Bearing Cone
Machine “C” Spacer
Bearing Cup
Inner Spacer
Heavy Washer
Pulley Hub
Seal Spacer
Spindle
Housing
Seal Spacer
Outer Spacer
Bearing Cup
Snap Ring
Bearing Cone