Setup Instructions

Step

Checking the Machine for

Grease

Parts needed for this step:

1 tube

Number 2 general purpose lithium base

or molybdenum base grease. (Purchase

separately.)

Procedure

1. R emo v e the belt co v ers .

2. Chec k the tensioning ar m for g rease .

3. Chec k the g rease for the three spindle bearings .

If needed, add g rease until it comes out of the

lo w er seals .

4. Install the belt co v ers .

Figure 18

Step

Checking the Engine Oil

Level

No Parts Required

Procedure

Before y ou star t the engine and use the mac hine ,

c hec k the oil lev el in the engine crankcase; refer to

Chec king Oil Lev el in Operator’ s Manual.

Step

Preparing the Side

Discharge Chute

No Parts Required

Procedure

R emo v e the plastic tie holding the side disc harg e

c hute up and lo w er the c hute into place .