Service Manual

3-22 Z Master Z400 Service Manual

CHASSIS

Brake Band Removal (Pro Series)

Note: Procedure can be used for left hand or right

hand.

1. Raise the right rear wheel (Fig. 106).

Fig 106 PICT-0229

2. Remove the four wheel lug nuts. Remove the wheel

assembly.

4. If the measurement is not correct, proceed to the

following steps.

5. Remove the hairpin and cotter pin from the brake

linkage (Fig. 105).

Fig 105 Firgure 44

6. Adjust the yoke clockwise to shorten the distance;

counterclockwise to lengthen distance (Fig 105).

7. Measure the distance vertically between the front

of the brake bar and the crown of the tire; the

measurement should be 7/8” to 1” (22 to 25mm)

(Fig. 104).

8. Repeat steps 5 through 7 if additional adjustment is

needed.

9. Engage the parking brake (lever up) and ensure the

brake bar engages the tire (Fig. 104).

1. Brake linkage 3. Hair pin and cotter pin

2. Yoke