Service Manual

310-2400/2600 IZT
28
CENTER SECTION, CYLINDER BLOCKS AND BYPASS
8. Install the two pins (43).
9. Install the by-pass plate (38) into the center
section (3). Install the center section (3) and
motor cylinder block assembly (21).
10. Install the three screws (44) that hold the
center section (3) in place.
11. Install the thrust bearing assembly (25).
Note: Install the thrust bearing assembly
with the thick race towards the pistons.
12. Install the motor shaft and bevel gear. See
page 26.
13. Install the filter and lower housing. See
page 24 and 25.
14. Install the axle shaft and spur gear. See
pages 22 and 23.
15. Install the brake shaft and bevel gear. See
page 21.
16. Install the brake. See pages 19 and 20.
17. Install the back cover. See page 18.
Figure 16. Center Section, Cylinder Blocks and Bypass
1
10
11
39
24
14
15
3
44
21
25
38
40
41
42
43
43
31