Service Manual

ZT-2200 (EZT
®
) 21
DISC BRAKE ASSEMBLY
160
159
158
74
75
157
156
2X 155
73
154
153
151
2X 150
100
153
10
Figure 11. Disc Brake Assembly
Refer to Figure 11.
Disassembly
1. Remove the control arm and bypass arm.
See page 18.
2. Remove the oil from the transaxle. See page
11.
3. Remove the brake arm bias spring (75).
4. Remove the cotter pin (160), castle nut (159)
and washer (158).
5. Remove the brake arm (74), compression
spring (156) and two brake pins (155).
6. Remove the brake yoke assy screws (73
& 157), the spacer (154), brake yoke assy
(153), puck plate (151), outer puck (150),
rotor (100) and inner puck (150).
7. Remove the motor shaft lip seal (10), if re-
moving the side housing.
Inspection
1. Check the brake disc and pucks for exces-
sive wear. Replace if necessary.
2. Check for excessive looseness at the arm
pivot point.
Assembly
1. Install the motor shaft lip seal (10), if re-
moved. Refer to page 17. Remember to use
a seal protector during installation.
2. Install the inner puck (150), rotor (100), outer
puck (150) and puck plate (151).
3. Install the brake yoke assy (153), brake pins
(155), spacer (154) and the brake yoke assy
screws (73 & 157).
4. Install the compression spring (156), the
brake arm (74), the washer (158), the castle
nut (159) and the cotter pin (160).
5. Install the brake arm bias spring (75).
7. Fill the transaxle with new oil. See page
11.
8. Install the bypass arm and control arm. See
page 18.