Setup Instructions

FormNo.3363-807RevA

TimeCutter™RidingMowers

ModelNo.Allmodels

SetupInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Setupthemotioncontrollevers.

Nopartsrequired

–

Connectthebattery.

IgnitionKey1

Hosecoupling1

Operator’sManual

EngineOperator’sManual

OperatorTrainingMaterial

CompletetheSetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

SettingUptheMotionControlLevers

NoPartsRequired

Procedure

1.Removetheupperbolt(3/8x1inch)andwasher;loosenthelowerbolt(3/8x1inch)asshowninFigure1.

Raisethemotioncontrollevers.

2.Aligntheholesinthemotioncontrolleverwiththeholesinthecontrolarmshaftandinstalltheboltandwasher

removedpreviously(

Figure1).Handtightenallfasteners.Repeatthisforbothcontrolslevers.

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3363-807 Rev A TimeCutter™ Riding Mowers Model No. All models Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty. No parts required – Set up the motion control levers. No parts required – Connect the battery. Ignition Key Hose coupling Operator’s Manual Engine Operator’s Manual Operator Training Material 1 1 1 1 1 Complete the Setup.
PAGE 2
3. Open the motion control levers and raise the seat (Figure 2). Move the control levers back to the center position (neutral). G006481 Figure 2 4. Verify the motion control levers are properly aligned (Figure 3). Adjust as necessary. Tighten all fasteners.
PAGE 3
2 3 Connecting the Battery Completing the Setup No Parts Required Parts needed for this procedure: Procedure 1. Locate the battery and negative battery cable in the left hand console of the machine. 2. Remove the fasteners on the negative battery post and use them to secure the negative battery cable to the negative battery post (Figure 4).
PAGE 4