Service Manual

ELECTRICAL
7-9TimeCutter® Z/Precision® Z Service Manual
7
Park Brake Switch
Purpose
How It Works
Testing
1 Disconnect the switch from the wiring harness.
 8VLQJD920RUWHVWOLJKWFKHFN¿UVWWRHQVXUHWKHUH
is no continuity between either terminal, plunger out.
3. With the plunger pushed in, there should be
continuity between the terminals.
Used to ensure the transaxles are in neutral and the park
brakes are engaged. It is activated when the forward/
reverse control levers are in the park position (handles in
the out position).
This single pole plunger type switch has two terminals.
When the forward/reverse control levers are in the
park position (handles in the out position), it pushes on
the plunger, closing the contact, and connecting the
terminals (Fig. 445).
Fig. 445 IMG-0476
Location
The park brake switches are located at the base of
the actuator arm linkage. There are 2 parking brake
VZLWFKHV2QHIRUULJKWVLGHOLQNDJHDQGWKHRWKHUIRUWKH
left side linkage (Fig. 444).
Note: LH pod removed for picture clarity.
Fig. 444 PICT-9740