Service Manual

ENGINE

4-6 TimeCutter® Z/Precision® Z Service Manual

5. Plug the engine wire harness into the main wiring

harness (Fig. 240).

6. Install the z-bend of the throttle/choke cable into the

middle hole of the engine linkage (Fig. 241).

7. Install the throttle/choke cable into the cable clamp,

before tightening the clamp, make sure the throttle

control is in the low idle setting (Fig. 242). Also,

make sure the throttle linkage on the engine carbur-

etor is pushed to far left stop position (Fig. 243).

Tighten the clamp.

Fig. 240 PICT-9522a

Fig. 241 PICT-9520

Fig. 242 PICT-9534

Fig. 243 PICT-9532