Service Manual

CHASSIS
3-43TimeCutter® Z/Precision® Z Service Manual
3
10. Plug the relay into the relay base (Fig. 171).
9. Install the throttle/choke cable and the wiring har-
ness in the wire clamp located on the right side of
the seat/pods bracket (Fig. 170).
Fig. 170 PICT-9443
Fig. 171 PICT-9445
8. On the left side of the seat/pods bracket install the
wiring harness into the wire clamp (Fig. 169).
7. Install the relay base with one screw and tighten it
down to the seat/pods bracket (Fig. 168).
Fig. 168 PICT-9441a
Fig. 169 PICT-9442