Service Manual

CHASSIS
3-51TimeCutter® Z/Precision® Z Service Manual
3
12. Remove the arm-lift from the frame (Fig. 201).
11. Remove the bolt, washer and nut retaining the pivot
block for the arm-lift on either the right or left side of
the frame (Fig. 200). Loosen the bolt, washer, and
nut on the other side.
Fig. 200 PICT-9467
Fig. 201 PICT-9472
Arm-Lift, Rear, Installation
1. Loosely install the pivot block with the round tab
(Fig. 202) into the hole located below the bolt, wash-
er, and nut to the frame (Fig. 203).
13. Remove the pivot block located on the other side of
the frame.
Fig. 202 PICT-9478a
Fig. 203 PICT-9481