Service Manual

CHASSIS

3-1TimeCutter® Z/Precision® Z Service Manual

0RGHO6HULDO1XPEHU,GHQWL¿FDWLRQ

)URQW&DVWRU)RUN5HSODFHPHQW

*UHDVH/XEULFDWLRQ

The unit model and serial number plate is located on the

frame under the seat as shown (Fig. 004):

 $JUHDVH¿WWLQJLVORFDWHGRQHDFKIURQWZKHHOKXE

(Fig. 006).

Fig. 004 PICT-9150

Fig. 006 PICT-9157

1. Park the unit on a level surface, disengage the blade

control (PTO), and turn the ignition key to “Off” to

stop the engine. Remove the ignition key.

2. Raise the front of the unit high enough to permit re-

moving the caster forks from the front axle assembly

(Fig. 007).

The unit should be greased every 25 hours or more

often when operated in dusty, dirty, or sandy conditions.

Grease Type: No. 2 general purpose lithium base

grease.

 6RPHPRGHOVKDYHDJUHDVH¿WWLQJRQWKHFDVWHUIRUN

area (Fig. 005).

Fig. 007 PICT-9158

Fig. 005 PICT-9154a