Service Manual

A6-15TimeCutter Z / Precision Z Service Manual

48” MOWER DECKS

12. To raise the front of the mower, tighten the adjust-

ment nuts. To lower the front of the mower, loosen

the adjustment nuts.

14. When the front-to-rear blade slope is correct,

tighten the locknuts and check the side-to-side

level of the mower; refer to Leveling the Mower

from Side-to-Side.

Fig A6 006 ﬁ g. 46 G000547

Fig A6 005 ﬁ g. 45 G000546

13. After adjusting both adjustment nuts evenly, check

the front-to-rear slope again. Continue adjusting the

nuts until the front blade tip is 1/16” - 5/16” (1.6 -

7.9mm) lower than the rear blade tip (Fig. A6 005).

Note: After adjusting the adjustment nuts, make

sure there is no slack in either support rod

(Fig. A6 006). Tighten either one to remove

the slack (Fig. A6 005).

11. To adjust the front-to-rear blade slope, remove the

locknuts and then rotate the adjustment nuts in the

front of the mower (Fig. A6 005).

A. Locknut and C. Adjustment nut

adjusting nut D. Locknut

B. Front tire

A. Hairpin cotter and B. Support rod

clevis