Service Manual

38”/42” MOWER DECKS

6 - 6 TimeCutter



Z Service Manual

Removing the Mower

Note: Before removing the mower, make a note for

which holes are used in the leveling brackets (Figure

102).

1. Park the machine on a level surface and

disengage the blade control (PTO).

2. Move the motion control levers to the brake

position, stop the engine, remove the key, and

wait for all moving parts to stop before leaving the

operating position.

3. Lower the height-of-cut lever to the lowest

position.

4. Remove the hairpin cotter and clevis pin from the

front support rod on each side of the mower

(Figure 101).

Figure 101

m-6431

5. Remove the hairpin cotter and washer from the

adjusting rod (Figure 102) on each side of the

mower.

6. Remove the hairpin cotter and washer at the

mower leveling brackets (Figure 102) on each

side of the mower. Note which hole the leveling

bracket is mounted in for future installation. Slide

the brackets off of the mounting pin.

Figure 102

m-6432

7. Slide the mower rearward to remove the mower

belt from the engine pulley.

8. Slide the mower out from underneath the tractor.

Note: Retain all parts for future installation.

(1) Hairpin cotter and clevis pin (2) Support rod

(1) Leveling bracket - 38 inch

model shown

(2) Hairpin cotter and

washer

(3) Adjusting rod