Service Manual

HYDRO-GEAR TRANSAXLE
4 - 6 TimeCutter

Z Service Manual
Transaxle Installation
1. Slide the hydro frame/transaxles under the frame
(Figure 43).
Figure 43
mvc-114
2. Lift the front of the hydro frame up into the frame,
making sure both the hydro rods and the brake
rods are in the right positions. Drop it down so the
notches in the hydro frame engage with the two
bolts and tubes located on the frame of the unit.
3. Before raising the rear portion of the transaxle,
connect the two hydro rods to the hydro control
arm (Figure 44).
Figure 44
mvc-115
4. Install the 4 bolts on both the right and left sides of
the frame and tighten (Figure 45).
Figure 45
mvc-739
5. Install and tighten the four bolts on the right and
left support brackets (Figure 46).
Figure 46
mvc-099
4