Service Manual

HYDRO-GEAR TRANSAXLE

TimeCutter



Z Service Manual 4 - 5

2. Remove the two bolts, washers, and nuts

securing the transaxle to the hydro frame and

remove the transaxle from the hydro frame (Figure

39).

Figure 39

mvc-110

3. NOTE: If you are replacing the transaxle, after

installing the hydro rods, remove the nut and

washer on the cam plate (Figure 40).

Figure 40

mvc-206

Assembly

Reverse the order of removal.

Wheel Hub Removal

1. Remove the bolt holding the locking tab to the hub

(Figure 41).

Figure 41

mvc-111

2. Remove the center hub bolt and washer. Slide

the hub off the axle shaft (Figure 42).

Figure 42

mvc-113

Installation Wheel Hub

Reverse the order of removal. Apply anti-seize

lubricant on the axle and apply Loctite 242 to the

threads of the bolt holding the locking tab and tighten.