Service Manual

CHASSIS

TimeCutter



Z Service Manual 3 - 7

Belt Replacement

Removal

1. Before removing or replacing the belt, disconnect

the negative battery cable and shut the fuel off at

the fuel valve, located under the fuel tank.

2. Remove the mower drive belt from the electric

PTO clutch.

3. Disconnect the plug connection to the electric

clutch (Figure 22).

Figure 22

mvc-079

4. Remove the PTO clutch bolt and remove the

electric clutch (Figure 23).

Figure 23

mvc-081

5. Disconnect the spring connected to the rear idler

arm and remove the lower drive belt off the engine

pulley and around the left transaxle pulley (Figure

24).

Figure 24

mvc-083

6. Disconnect the front idler spring from the front

spring bracket and work the belt off the right

transaxle pulley, then off the engine pulley (Figure

25).

Figure 25

mvc-084