Operator's Manual

m–6418

Figure 14

1. Position for operating the

machine

2. Position for pushing the

machine

To Operate the Machine

Push the two bypass levers towards the inside and then pull

them rearward (Fig. 14).

Note: The machine will not drive unless the bypass levers

are pushed in and then to the outside.

Adjusting the Footrest

The footrest can be adjusted forward or backward for

maximum operator comfort.

1. Lift up the footrest and place the rods in the same hole

positions (Fig. 15).

m–6423

Figure 15

1. Footrest

2. Rod

3. Hole positions

Removing and Installing the

Engine Hood

1. To remove the hood, loosen the knobs and then pull the

hood back and up (Fig. 16).

m–6424

Figure 16

1. Engine hood 2. Knob

2. To install the hood, put the hooks into the slots and slide

forward (Fig. 17).

3. Install the knobs into the engine hood (Fig. 16).