Service Manual

Toro®- Z Master® 8000 Series Service Manual 7-9
7
September 2016
Table of Contents
MOWER DECK AND DECK DRIVE
11. Remove both belts from the deck drive jackshaft
pulley.
12. Remove the belts from the tensioner/idler pulley on
the left side of the unit.
13. Route belts above the lower belt guide.
14. Pull the belt slack to the left side of the unit.
15. Remove the belts from the engine pulley.
16. Remove the belts from the unit.
Installation
1. Install the two new belts onto the crankshaft pulley
from beneath the unit (Figure 99).
2. Route the belts, pull the belt slack to the left side of
the unit (Figure 100).
Figure 99
Figure 100