Service Manual

7-19Z Master 500 Gas Series Service Manual

MOWER DECKS/PTO

Fig 419 DSC-2682

Fig 421 DSC-2688

14. Remove the large spacer in the spindle housing (Fig.

419).

1. Install the spacer through the top of the spindle

housing (Fig. 421).

Fig 420 DSC-2684

Fig 418 DSC-2681

15. This view shows the 2 bearing races and the large

spacer in the spindle housing (Fig. 420). Note the

internal snap ring in the housing, it is not necessary

to remove when installing new bearing races and the

spacer.

13. Using a hammer and a driver with a square edge,

drive both the top and bottom bearing races out of

the spindle housing (Fig. 418).

Mower Spindle Assembly

A. Bearing race B. Spacer