Service Manual

3-18 Z Master 500 Gas Series Service Manual
3
CHASSIS
5. Install hex bolt through deck lift plates and rear
lift arm cross shaft bushing. Install nylock nut and
tighten (Fig. 081).
Fig 081 DSC-1675
6. Rotate deck lift plate (inner) downward until lower
mounting holes line up with hole in carrier frame and
deck lift plate (outer). From the outside of the frame,
install hex bolt, spacer, and anged lock nut as
shown. Tighten bolt (Fig. 082).
Fig 082 DSC-1677
Fig 080 DSC-1674
4. Install bushing into rear lift arm cross shaft (Fig.
080).
Fig 083 DSC-1680
7. Align rear deck mount swivels with ends of deck lift
rod (Fig. 083).
A. Bushing
A
A. Rear lift arm plates B. Hex bolt
A
A
B
A. Hex bolt B. Spacer
C. Flanged locknut
A. Rear deck mount B. Lift rod
swivel
A
B
C
A
B