Service Manual

4-24 Z Master Z597 Diesel Service Manual

HYDRAULIC SYSTEM

Fig 201 DSC-2355

3. Disconnect the electrical connector from the seat

safety switch. Temporarily install a jumper wire

across terminals in the wiring harness connector

(Fig. 201).

Adjusting the Handle Neutral

If motion control levers do not align, or move easily into

the console notch, adjustment is required. Adjust each

lever, spring and rod separately.

Note: Motion control levers must be installed

correctly. See Installing the Motion Control

Levers in the Set Up instructions.

1. Disengage the PTO, move the motion control levers

to the neutral locked position and set the parking

brake.

2. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating

position.

Fig 202 m-7510

6. Pull lever back until the clevis pin (on arm below

pivot shaft) contacts the end of the slot (just

beginning to put pressure on the spring) (Fig. 202).

1. Clevis pin in slot 7. Spring

2. Nut against yoke 8. Pivot shaft

3. Adjustment bolt 9. Yoke

4. Pump rod 10. Locknut

5. Double nuts 11. Ball joint

6. Jam nut 12. Tracking knob

3. Unlatch the seat and tilt the seat up.

4. Begin with either the left or right motion control lever.

5. Move lever to the neutral position but not locked

(Fig. 202).