Service Manual

4-7Z Master Z597 Diesel Service Manual

HYDRAULIC SYSTEM

9. Using a 3/8” drive ratchet, insert the wrench into

the square hole in the pump belt tensioner arm and

relieve the tension to install the hydrostatic pump

v-belt (Fig. 139).

Fig 139 DSC-2073

10. Install two cable ties for the fuel line and the wiring

harness (Fig. 140).

Fig 140 DSC-2101

Fig 141 DSC-2071

11. Install the battery in the unit and connect the positive

and negative battery cables.

12. Check the hydraulic uid in the reservoir tank. Add

oil if necessary, refer to Figure 006, page 2-5. Air

will need to be purged in the system. Follow the

procedures on Purging the Hydraulic System, page

4-13.

13. Check the neutral adjustment. Follow procedures

for Adjusting the Handle Neutral, page 4-24.

14. Install the engine belt shield and the engine access

panel. Install the two knobs (Fig. 141).