Service Manual

6-18 Z Master 597 Diesel Series Service Manual

ELECTRICAL

Back side of the Temperature Gauge with terminal and

wire locations (Fig. 375).

S Terminal - Yellow/Red Wire (to Temperature

Sender)

G Terminal - Black Wire (Ground)

I Terminal - Orange Wire (I Terminal of the Ignition

Switch)

Fig 375 DSC-2551

The hour meter keeps track of the actual unit running

hours or the time that the ignition key switch is in the

RUN position.

Fig 377 DSC-2560

Since a normal clock might be affected by variations in

voltage and current, the hour meter is made up of an

electric “winder” and a mechanical clock movement.

When power is applied, a coil is energized to wind the

movement. The movement unwinds in about 2 seconds.

As it nishes its rotation, it re-energizes the coil so that

the cycle can start over (Fig. 377).

Fig 376 DSC-2559

Raise the seat, the hour meter is located on the left side

of the operator on the lower portion of the control panel

(Fig. 376).

Location

Purpose

HOUR METER

How It Works