Service Manual

11
15
CHARGING SYSTEMS
3. Assemble brush end housing to drive end housing
with reference marks aligned, Fig. 38.
Note: Do not damage stator leads.
4. Install thru bolts and nuts.
a. Torque to 5.0 Nm (45 in. lbs.).
Fig. 38 – Assemble Housings
5. Align stator wires with holes in rectifier and
assemble rectifier to brush end housing, Fig. 39.
6. Carefully form a “U” bend in stator wires.
a. Install screws and tighten securely.
Fig. 39 – Install Rectifier
RECTIFIER
7. Install regulator with three screws shown, Fig. 40.
Fig. 40 – Install Regulator
8. Assemble cover to brush holder, Fig. 41.
Fig. 41 – Install Brush Cover
COVER