Operator's Manual

10. Install the fan and fan plate to the mac hine with
the 2 bolts previously remo v ed ( Figure 62 ).
11. Install the oil cooler with the 4 bolts previously
remo v ed ( Figure 62 ).
12. Install the oil cooler shield and engine straps
to the rear frame with the 4 bolts previously
remo v ed ( Figure 61 ).
13. Install the engine straps to the side of the
mac hine ( Figure 61 ).
14. Tighten the bottom bolt and install the
upper bolt holding the alter nator and co v er
( Figure 63 ).
Tensioning the Alternator Belt
1. Place a handle betw een the alter nator and
cylinder bloc k.
2. Adjust the alter nator to the outside until
there is 1/4 to 11/32 inc h (7 to 9 mm)
deflection in the belt betw een the engine and
the alter nator pulleys with 22.1 lbs of force (10
kgf) ( Figure 63 ).
3. Tighten the alter nator bolts .
4. Chec k the deflection in the belt ag ain and
adjust the belt if needed.
5. If the deflection is cor rect, tighten the bottom
and upper bolt ( Figure 63 ).
Figure 63
1. Alternator 4. Top bolt
2. Alternator belt 5. Bottom bolt
3. Deection, 1/4 to
11/32 inch (7 to 9 mm)
with 22.1 lbs of force (10
kgf)
Controls System
Maintenance
Adjusting the Control
Handle Neutral Position
If motion control lev ers do not align, or mo v e
easily into the console notc h, adjustment is
required. Adjust eac h lev er , spring and rod
se parately .
Note: Motion control lev ers m ust be installed
cor rectly . See Installing the Motion Control Lev ers
in the set up instr uctions .
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Unlatc h the seat and tilt the seat forw ard.
48