Operator's Manual

T her e is no r ollo v er pr otection when the r oll
bar is in the do wn position.
• Lo w er the r oll bar onl y when a bsolutel y
necessar y .
• Do not w ear the seat belt when the r oll
bar is in the do wn position.
• Dri v e slo wl y and car efull y .
• R aise the r oll bar as soon as clearance
per mits.
• Check car efull y f or o v erhead clearances
(i.e. branches, doorw ays, electrical wir es)
bef or e dri ving under an y objects and do
not contact them.
Important: Lo w er the r oll bar onl y when
a bsolutel y necessar y .
1. T o lo w er the roll bar , loosen the front knobs
( Figure 8 ).
2. R emo v e the hair pin cotter pins and remo v e the
tw o pins( Figure 7 ).
3. Lo w er the the roll bar to the do wn position.
T here are tw o do wn positions . See Figure 6
for the positions .
4. Install the tw o pins and secure them with the
hair pin cotter pins ( Figure 7 ).
Figure 6
1. Full down position 2. Down position with bagger
installed
Important: Ensur e that the r ear par t of
the seat is secur ed with the seat latch.
5. T o raise the roll bar , remo v e the hair pin cotter
pins and remo v e the tw o pins ( Figure 7 ).
6. Raise the roll bar to the upright position and
install the tw o pins and secure them with the
hair pin cotter pins ( Figure 7 ).
Important: Al w ays use the seat belt with
the r oll bar in the raised position.
Figure 7
1. Roll bar
3. Pin
2. Raised position
4. Hairpin cotter pin
Important: Tighten the fr ont knobs
a gainst the center r oll bar ends ( Figur e 8 ).
Figure 8
1. Front handle
18