Operator's Manual
Table Of Contents
- NO TITLE
- NO TITLE
- NO TITLE
- Adding Fuel
- Biodiesel Ready
- Filling the Fuel Tank
- Checking the Engine-Oil Level
- Switching the Fuel Tanks
- Using the Rollover Protection System (ROPS)
- Think Safety First
- Operating the Parking Brake
- Starting and Stopping the Engine
- Operating the Power Takeoff (PTO)
- Using the Safety-Interlock System
- Driving Forward or Backward
- Stopping the Machine
- Adjusting the Height of Cut
- Adjusting the Anti-Scalp Rollers
- Adjusting the Flow Baffle
- Positioning the Flow Baffle
- Using the Lift-Assist Lever
- Positioning the Seat
- Changing the Seat Suspension
- Unlatching the Seat
- Pushing the Machine by Hand
- Using the Side Discharge
- Operating with the Overheat Sensor
- Transporting the Machine
- Loading the Machine
- Using the Z Stand™
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
6.Recordthismeasurement.Thismeasurementneedsto
be80to83mm(3-1/8to3-1/4inches).
7.IfthemeasurementsatpositionsBorCarenot
correct,loosentheboltattachingtherearchaintothe
rearsupportarm(Figure81).
Figure81
1.Rearchain5.Adjustmentbolt
2.Rearsupportarm6.Frontswivel
3.Bolt7.Frontsupportarm
4.Jamnut
8.Loosenthejamnutundertherearsupportarmand
adjusttheadjustmentbolttogetameasurementof80
to83mm(3-1/8to3-1/4inches)(Figure81).
Note:Itisrecommendedthatbothsidesofthe
mowerareadjustedthesamedistance.
9.Tightenthejamnutundertherearsupportarmand
tightentheboltsecuringthechaintotherearsupport
arm.
10.Adjusttheoppositesideifneeded.
AdjustingtheFront-to-RearMower
Pitch
1.Positiontherightbladefront-to-rear(Figure82).
2.MeasuretherightbladeattheAlocation,fromalevel
surfacetothecuttingedgeofthebladetip(Figure82).
Figure82
1.Measureherefromthe
bladetoahardsurface.
2.MeasureatAandB.
3.Recordthismeasurement.
4.MeasuretherightbladeattheBlocation,fromalevel
surfacetothecuttingedgeofthebladetip(Figure82).
5.Recordthismeasurement.
6.Themowerbladeshouldbea6to10mm(1/4to
3/8inch)loweratpositionAthanatpositionB(Figure
82).Ifitisnotcorrect,proceedtothefollowingsteps.
Note:Bothofthefrontswivelsneedtobeadjusted
thesameamounttomaintainequalchaintension.
7.Loosenthefrontswiveljamnuts,atthefrontofthe
rightandleftswivels,approximatelya13mm(1/2inch)
(Figure81).
8.Adjusttheliftnutsonboththeleftandtherightsideof
themachinetoachieve6to10mm(1/4to3/8inch)
lowerinfrontatAthanintherearatB(Figure81).
9.Tightenbothswiveljamnutsagainstthefrontswivel
tolocktheheight.
10.Checktomakesurethatthereisequaltensiononthe
chainsandadjustagainifneeded.
59