Operator's Manual
Table Of Contents
- NO TITLE
- NO TITLE
- NO TITLE
- Adding Fuel
- Biodiesel Ready
- Filling the Fuel Tank
- Checking the Engine-Oil Level
- Switching the Fuel Tanks
- Using the Rollover Protection System (ROPS)
- Think Safety First
- Operating the Parking Brake
- Starting and Stopping the Engine
- Operating the Power Takeoff (PTO)
- Using the Safety-Interlock System
- Driving Forward or Backward
- Stopping the Machine
- Adjusting the Height of Cut
- Adjusting the Anti-Scalp Rollers
- Adjusting the Flow Baffle
- Positioning the Flow Baffle
- Using the Lift-Assist Lever
- Positioning the Seat
- Changing the Seat Suspension
- Unlatching the Seat
- Pushing the Machine by Hand
- Using the Side Discharge
- Operating with the Overheat Sensor
- Transporting the Machine
- Loading the Machine
- Using the Z Stand™
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
- NO TITLE
Figure70
1.Gearbox4.Clutch
2.Spring
5.Rubberclutchstop
3.Spring-loadedidlerpulley6.PTOdrivebelt
ReplacingthePumpDriveBelt
ServiceInterval:Every50hours—Checkthepumpdrive
belt.
Note:RemovethePTOdrivebeltrstifthepumpdrive
beltneedstobereplaced.
1.Tilttheseatforward,loosentheboltsandremovethe
frontenginepanel.
2.RemovethePTOdrivebelt.
3.Removethespringfromtheidlerarm(Figure71).
4.Installthenewbeltaroundtheengineandhydropump
pulley(Figure71).
5.InstallthePTOdrivebelt.
6.Installthespringtotheidlerarm(Figure71).
7.Installthefrontenginepanel.
Figure71
1.Clutch3.Spring
2.Pumpdrivebelt
4.Spring-loadedidlerpulley
52