Operator's Manual

Figure 66
1. Hydraulic lter
4. R emo v e the righthand h y draulic line that
comes into the adapter ( Figure 67 ).
5. Allo w the oil to drain out of the system into
the drain pan.
6. Install the righthand h y draulic line to the
adapter ( Figure 67 ).
Figure 67
1. Righthand hydraulic line 3. Hydraulic tank
2. Hydraulic lter
7. Apply a thin coat to the r ubber g ask et on the
re placement filter ( Figure 68 ).
8. Install the re placement h y draulic filter onto the
filter adapter . Do not tighten.
9. Fill the h y draulic tank with h y draulic fluid until
the fluid o v erflo ws the filter and then tur n
the oil filter cloc kwise until the r ubber g ask et
contacts the filter adapter , then tighten the
filter an additional 1/2 tur n ( Figure 68 ).
10. Clean up any spilled fluid.
11. Add fluid to the cold lev el of the baffle in the
h y draulic tank.
12. Star t the engine and let it r un for about tw o
min utes to purg e air from the system. Stop
the engine and c hec k for leaks . If one or
both wheels will not dri v e , refer to Bleeding
Hy draulic System.
13. R ec hec k the fluid lev el while the fluid is w ar m.
T he fluid should be betw een cold and hot.
14. If required, add fluid to the h y draulic tank. Do
not o v erfill.
Figure 68
1. Hydraulic lter 3. Adapter
2. Gasket
Bleeding the Hydraulic System
T he traction system is self bleeding, ho w ev er , it
ma y be necessar y to bleed the system if fluid is
c hang ed or after w ork is perfor med on the system.
1. Raise rear of the mac hine so wheels are off the
g round and suppor t with jac k stands .
2. Star t the engine and r un at lo w idle speed.
Eng ag e the lev er and traction on one side and
spin the wheel b y hand.
3. W hen the wheel begins to spin on its o wn,
k ee p it eng ag ed until wheel dri v es smoothly .
(minim um 2 min utes)
4. Chec k h y draulic fluid lev el and add as required
to maintain proper lev el.
5. R e peat this procedure on the opposite wheel.
Checking the Hydraulic Hoses
After ev er y 100 operating hours , c hec k the
h y draulic hoses for leaks , loose fittings , kink ed
lines , loose mounting suppor ts , w ear , w eather and
c hemical deterioration. Mak e necessar y re pairs
before operating .
Note: K ee p areas around the h y draulic system
clean from g rass and debris build up .
51