Manual

Drive System
Maintenance
Adjusting the Tracking
The machine has a knob for adjusting the tracing
located under the seat.
Important: Adjust the handle neutral and
hydraulic pump neutral before adjusting
the tracking. Refer to Adjusting the Handle
Neutral in Controls System Maintenance,
page 48 and Adjusting the Hydraulic Pump
Neutral in Hydraulic System Maintenance,
page 49.
1. Push both control levers forward the same
distance.
,
,
,
Check if the machine pulls to one side• If it
does, stop the machine and set the paring
brake.
Unlatch the seat and tilt the seat forward to
access the tracing knob.
Note: Determine the left and right sides
of the machine from the normal operating
position.
To make the machine go right, turn the knob
towards the rightside of the machine. Refer to
Figure 47.
To make the machine go left, turn the M_ob
towards the leftside of the machine. Refer to
Figure 47.
6. Repeat adjustment until the tracing is correct•
40