Service Manual

6-8 Z Master 500 Gas Series Service Manual
6
ELECTRICAL
PARK BRAKE SWITCH
Purpose
The purpose of the brake switch is to ensure the
machine is in neutral and the parking brake is applied
before attempting to start the machine.
The park brake switch is located on the left side of the
operators below the left motion control handle (Fig. 334).
Fig 334 DSC-2525
1. Disconnect the switch from the wiring harness.
Fig 335 DSC-2528
In the start position it is used to ensure the park brake is
“ON”. At the same time it allows current to ow through
for the safety circuit. When the park brake is released in
the “OFF” position it bypasses both neutral switches as
long as the operator is in the seat thereby maintaining
current for the safety circuit (Fig. 335).
Location
How It Works
Testing