Operator's Manual

T his adjustment m ust be made with dri v e wheels
tur ning .
1. Raise the frame and use jac k stands to hold up
the mac hine so dri v e wheels can rotate freely .
2. Unlatc h the seat, tilt the seat forw ard and
disconnect electrical connector from the seat
safety switc h.
3. T emporaril y install a jumper wire across
ter minals in the wiring har ness connector .
4. Slide the seat forw ard, disconnect the prop rod
and tilt the seat fully forw ard.
Setting the Right-hand Hydraulic
Pump Neutral Position
1. Star t the engine , open the throttle 1/2 w a y and
release parking brak e . R efer to Star ting and
Stopping the Engine in Operation , pag e 15 .
Note: T he motion control lev er m ust be in
neutral while making any adjustments .
2. Adjust the pump rod length b y rotating the
knob , in the appropriate direction, until the
wheel is still or slightly cree ping in rev erse
( Figure 67 ).
Figure 67
1. Tracking knob 3. Adjustment bolt
2. Pump rod 4. Yoke
3. Mo v e the motion control lev er forw ard and
rev erse , then bac k to neutral. T he wheel m ust
stop tur ning or slightly cree p in rev erse .
4. Open the throttle to fast. Mak e sure wheel
remains stopped or slightly cree ps in rev erse ,
adjust if necessar y .
Setting the Left-hand Hydraulic Pump
Neutral Position
1. Loosen the loc kn uts at the ball joints on the
pump control rod ( Figure 68 ).
Figure 68
1. Clevis pin in slot
7. Spring
2. Nut against yoke 8. Pivot shaft
3. Adjustment bolt 9. Yoke
4. Pump rod 10. Locknut
5. Double nuts 11. Ball joint
6. Jam nut
2. Star t the engine , open throttle 1/2 w a y , and
release parking brak e . R efer to Star ting and
Stopping the Engine in Operation , pag e 15 .
Note: T he motion control lev er m ust be in
neutral while making any adjustments .
Note: T he front n ut on the pump rod has
left-hand threads .
3. Adjust the pump rod length b y rotating double
n uts on rod, in the appropriate direction,
until wheel is still or slightly cree ps in rev erse
( Figure 68 ).
50