Service Manual

HYDRAULIC SYSTEM

4-21Z580/Z589 DFI Z Master Service Manual

Note: As a reminder, prior to connecting the hy-

draulic lines, the o-rings should be replaced

with new ones and lightly lubricated with

petroleum jelly.

Note: There are two different spacers used on the

wheel motors (Fig. 307). The short spacers

are used in the front of the wheel motor (with

the brake linkage) and the long spacers are

used to retain the back of the wheel motor.

Fig 307 DSC-2117a

A. Short spacer B. Long spacer

Wheel Motor Installation

A B

1. Insert the wheel motor into the frame. Loosely install

the 2 rear wheel motor mounting bolts, long spacers

and nuts (Fig. 308).

Fig 308 PICT-3377a

2. Swing the brake linkage into position (Fig. 309).

Fig 309 PICT-3374a