Service Manual

BDP-10A/16A/21L

REMOVAL, INSPECTION AND AS-

SEMBLY OF THE END CAP AND

VALVE PLATE BDP-10A

Refer to Figure 22.

Disassembly BDP-10A

1. Using a 10 mm wrench, loosen the end cap

bolts (4) evenly.

2. Keeping the end cap (2) held in place, re-

move the four end cap bolts (4).

3. Slowly remove the end cap (2).

4. Remove the valve plate (31).

5. Remove housing alignment pins (3).

6. Remove housing gasket (5).

Inspection BDP-10A

1. Inspect the end cap (2) body for damage,

nicks or unusual wear patterns. Replace if nec-

essary.

2. Inspect the running surface (side that con-

tacts the cylinder block) of the valve plate (31).

The running surface may show evidence of

minor abrasive rings.

This is normal. Grooving in the plate, or material

transfer that is evident when the surface is

checked by dragging a fingernail across it, would

be cause for replacement of the valve plate.

3. Inspect and replace alignment pins (3) if bent

or distorted.

4. Replace the housing gasket (5) with a new

gasket before reassembly.

Assembly BDP-10A

1. Install housing gasket (5) into housing gasket

seat in housing (1).

2. Install alignment pins (3) into housing (1).

3. Lubricate the valve plate prior to installation.

Install valve plate (31) so the stamped letters “CL”

on the valve plate are facing up toward the

endcap.

4. Install end cap (2). Before installing the four

end cap bolts (4), push down on end cap (2)

verifying alignment and insuring that the cylinder

block pistons spring back and forth. Install end

cap bolts (4). Tighten, reference Table 4, page

16, torque values.

Figure 22. BDP-10A