Service Manual

5-12 Z Master 500 Gas Series Service Manual

ENGINE

Fig 199 DSC-2982

Fig 197 DSC-2976

10. Install the hydrostatic pump drive belt, using a pry

bar to release the tension on the spring loaded idler

pulley (Fig. 199).

8. Plug the wire into the oil pressure sending unit

located next to the engine oil lter (Fig. 197).

Fig 196 DSC-2985

Fig 198 DSC-2975

7. Install the fuel line to the engine and tighten the hose

clamp. Turn the fuel shut off valve ON (Fig. 196).

9. Connect the throttle and choke cables to the engine

control linkage. Position the throttle control in the idle

position. Make sure the choke lever is pushed down

to the “Off” position when connecting the cable.

Tighten both cable clamps (Fig. 198).

A Choke Cable B Throttle Cable

A Fuel Valve B Fuel Line Clamp