Service Manual

5-17Z Master 500 Gas Series Service Manual
5
ENGINE
18. Remove the wire connector located at the bottom of
the ECU (Electronic Control Unit). First, remove the
red retainer clip (Fig. 216).
Fig 216 DSC-2907
Next, remove the multi-pin connector from the ECU
(Fig. 217).
Fig 217 DSC-2908
Fig 218 DSC-2910
19. Remove the wire clip located on the side of the ECU
that retains the test plug connector (Fig. 218).
Fig 215 DSC-2904
17. Remove the wire clamp bolted to the frame, located
on the left side of the engine (Fig. 215).