Service Manual

4-17Z Master 500 Gas Series Service Manual

5. To make the machine go left, turn the knob towards

the left side of the machine (Fig. 147, above).

6. Repeat this adjustment until the tracking is correct.

Fig 147 g. 57 m-6280

2. Stop the machine and set the parking brake.

3. Unlatch the seat and tilt the seat forward to access

the tracking knob.

Note: Determine the left and right sides of the

machine from normal operating position.

4. To make the machine go right, turn the knob towards

the right side of the machine (Fig. 147).

1. Pull the spring loaded idler down and remove

traction belt from the engine and hydro pump pulleys

(Fig. 148). Remove belt between the pulleys.

Replacing the Pump Drive Belt

Fig 148 DSC-3122

2. Install new belt around engine and hydro pump

pulleys (Fig. 149).

Fig 149 pump belt routing

3. Pull spring loaded idler down and align below

traction belt. Release pressure on spring loaded

idler.

HYDRAULIC SYSTEM

1. Pump rod 3. Tracking knob

2. Turn this way to 4. Turn this way to

track left track right