Service Manual

4-14 Z Master 500 Gas Series Service Manual

HYDRAULIC SYSTEM

3. Disconnect the electrical connector at the switch,

located between the frame cross member and the

hydraulic tank. Temporarily install a jumper wire

across the terminals in the wiring harness connector

(Fig. 141).

Setting the RH Hydraulic Pump

Neutral

Fig 141 DSC-3116

1. Start the engine, open the throttle half way and

release the park brake.

Note: The motion control lever must be in neutral

while making any adjustments.

2. Slide the seat fully forward, unlatch the seat and tilt

the seat forward. Disconnect the prop rod for the

seat.

Fig 140 DSC-3114

Note: Adjust handle neutral before making the

following adjustment. See Adjusting the

Handle Neutral, page 4-12.

Note: This adjustment must be made with the drive

wheels turning.

1. Raise the frame and block up the machine so drive

wheels can rotate freely (Fig. 140).

Setting the Hydraulic Pump Neutral