Setup Instructions

3
2. For an air cooled machine, loosen the two bottom
bolts in the rear bumper.
m–6886
3. For a liquid cooled machine, loosen the two side
and four back bolts in the rear bumper.
m–6885
Note: Step 4 is needed for international mowers only.
4. For internationl mowers, remove the bolts,
washers and nuts holding the rubber flap in front of
the motor.
m–7655
5. Install the bolts in the order shown in the figure
below.
6. Loosely install the right and left roll bar sections
to the frame, in numbered order as follows:
Lock nut (3/8 inch), curved washer
Bolt (3/8 x 1 inch), curved washer, and flange nut
(3/8 inch)
Bolt (3/8 x 1 inch), curved washer, and flange nut
(3/8 inch)
Bolt (3/8 x 4-1/2 inches), curved washer, and
flange nut (3/8 inch)
m–6854
7. Install the lanyard
clips onto the 2 bolts
(1/2 x 3-1/4 inches).
Note: Make sure the
bent tab points toward
the head of the bolt.
m–6892