Operator's Manual

23
m–6844
5
3
1
2
1
Figure 20
1. Anti–scalp roller
2. Spacer
3. Bushing
4. Flange Nut
5. Bolt
Adjusting the Flow Baffle
The mower discharge flow can be adjusted for different
types of mowing conditions. Position the cam locks and
baffle to give the best quality of cut.
1. To adjust the cam locks, swing the lever up to loosen
the cam lock (Fig. 25).
2. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
3. Swing the lever back over to tighten the baffle and
cam locks.
4. If the cams do not lock the baffle into place or it is too
tight, loosen the lever and then rotate the cam lock.
Adjust the cam lock until the desired locking pressure
is achieved.
m–6823
4
1
2
3
1
Figure 21
1. Cam lock
2. Lever
3. Rotate cam to increase or
decrease locking pressure
4. Slot
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments will vary by grass type, moisture content,
and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the mower.
m–6829
Full Rearward Position
Figure 22
Position B
Use this position when bagging.
m–6828
Middle Position
Figure 23