Operator's Manual
15
2. Place the levers (with the mounting plate toward the
rear) on the outside of the control arm shaft and secure
them with 4 bolts (3/8 x 1 in.) and 4 spring washers
(3/8 in.) (Fig. 3).
3. Position the levers so that the bolts are in the center of
the slots on the lever mounting plate and tighten until
snug.
4. Align the front\rear position of the levers, with each
other, in the neutral position. Loosen the hardware and
adjust by sliding/tilting the lever(s) forward or
backward until they are properly aligned (Fig. 3).
1
2
3
m–5596
4
5
6
Figure 3
1. Mounting plate
2. Bolt, 3/8 x 1 in.
3. Spring washer, 3/8 in.
4. Top hole
5. Middle hole
6. Bottom hole
5. If the ends of the levers hit against each other, while in
the drive position (Fig 4) (levers rotated in as far as
possible) make adjustments by moving the levers
outward to the neutral lock position and carefully bend
them outward. Move them back to the drive position
and check for clearance. Repeat if necessary.
Figure 4
Installing the Seat
1. Remove seat from crate.
2. Position seat on the studs in the adjustable tracks
(Fig. 5).
3. Install nuts onto studs (Fig 5).
4
1
m–4817
2
3
Figure 5
1. Seat
2. Studs
3. Adjustable track
4. Nuts
Activating the Battery
Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.
• Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the machine. Refer to
Removing the Battery on page 43.
2. Clean the top of the battery with a paper towel.
Note: Never fill the battery with electrolyte while the
battery is installed in the machine. Electrolyte could be
spilled on other parts and cause corrosion.
3. Remove the vent caps from the battery (Fig. 48).