Service Manual

5-6 Z Master 500 Gas Series Service Manual

ENGINE

6. Attach the two red cables to the starter solenoid (Fig.

174).

Fig 174 DSC-2964

Fig 176 DSC-2971

8. Install the fuel line to the engine and install a hose

clamp. Turn the fuel shut off valve to the ON

position (Fig. 176).

7. Install hydrostatic pump drive belt, using a pry bar to

relieve the tension on the spring loaded idler pulley

(Fig. 175).

9. Install the throttle and choke cables to the

throttle linkage. Position the throttle lever so it is

approximately 1/2” (12.7mm) from the full throttle

position. Make sure the choke lever is pushed down

to the OFF position. Then tighten both cable clamps

(Fig. 177).

Fig 175 DSC-2963

Fig 177 DSC-2959

A Throttle Cable B Choke Cable

A Fuel Valve B Fuel Line Clamp