Service Manual

3-4 Z Master 500 Gas Series Service Manual

Castor Fork Assembly

2. Install the upper bearing.

3. Install the Belleville (spring) washers as shown in

(Fig. 031).

A. Dust Cap

B. Locknut

C. Spring Washers

Fig 030 DSC-1533

Fig 031 washers line art

1. Install the castor fork into the frame (Fig. 030).

6. Install the lower bearing and seal, with the open end

of the seal facing up (Fig. 029).

Fig 029 DSC-1538

CHASSIS

4. Install the locknut and tighten until the spring

washers are at, then back off 1/4 turn to properly

set the preload on the bearings (Fig. 032).

Fig 032 DSC-1532